Technical data

Electrical Equipment

chap. 6

6-37

Release 00 2002-09

Atlantic 500

• Loosen and remove the two fixing screws (3) of

the protective screen (4) of the third stop light.

• Pull out the all-glass bulbs (5) from their housing.

• Correctly fit a bulb of the same kind.

CAUTION

NOTE During reassembly, correctly set the

protective screen in its housing.

Carefully and gently tighten the screw (3) in order

to avoid damaging the protective screen.

VERTICAL BEAM ADJUSTMENT

• To quickly check the alignment of the headlight

beam, place the vehicle on level ground, 10

metres from a vertical wall.

• Turn on the low beam, sit on the vehicle and

check that the top of the lighted area on the wall is

slightly lower than the projection of the headlight

axis (approximately 9/10 of the overall height).

To adjust the headlight beam:

• Use the special handle (1) from the front of the

vehicle.

• Turning it CLOCKWISE, the beam is raised.

• Turning it ANTICLOCKWISE, the beam is

lowered.