Technical data

Engine

chap. 3

3-5

Release 00 2002-09

Atlantic 500

Remove rubber protection (21) and detach the

engine oil pressure sensor wire connector (22).

Unloose and remove the nut fixing the starter relay

cable (23) and remove the cable (24).

Unloose and remove the two screws (25) fixing the

starter to the crankcase, and release the cables for

the ground.

Detach connector (26) of the injection positive cable.

Owing to the weight and bulk of the components

and the vehicle, the following operations are to be

performed in cooperation with a second operator.

Before starting work, the two operators should

agree on their respective roles in the operations to

be performed (in the following instructions “A”

operations are to be carried out by the 1st opera-

tor and “B” operations by the 2nd operator), on

the procedures to be followed and on any warning

signs to be placed.

EXERCISE EXTREME CAUTION.

WARNING

The weight and bulk of the vehicle can cause

dangerous unbalancing and tipping of the vehicle

during the hoisting phase.

PROCEED WITH CAUTION AND MAKE SURE YOU

CAN BEAR THE WEIGHT OF THE VEHICLE.

Remove the rear wheel, see (REMOVING THE REAR

WHEEL).

“A” Lift the vehicle from its rear side, fasten up the

wheel with belts if necessary.