Technical data

Electrical Equipment

chap. 6

6-17

Release 00 2002-09

Atlantic 500

STARTING RELAY CHECK

• Disconnect the two-way connector (1)(white).

During reassembly ensure correct coupling of the

electrical connector (1).

• Pull the relay out from the special hooks (2).

• Pull out the two rubber protectors (3-4).

• Disconnect the cables from their respective

terminals on the relay (2).

• Supply the two internal terminals to the connector

(1) with a 12V tension from the relay side.

• With a multimeter (set to Ohm meter mode) verify

the continuity between the two screw contacts on

the relay (2).

Correct value with supply to the relay: 0

ΩΩ

Ω

Correct value without supply to the relay: ∞

ΩΩ

Ω

If the resulting values do not correspond to those

prescribed, replace the relay (2).

CAUTION

STOP LIGHTS RELAY CHECK

To verify that the relay is working:

• To access the relay raise the saddle and remove

the left tail lamp, see (TAIL LAMP BULBS

REPLACEMENT).

• Supply the two male terminals (85-86) with a 12V

tension;

• With a multimeter (set to ohm meter mode) verify

the continuity between the other two terminals (87-

30).

Correct value with supply to the relay: 0

ΩΩ

Ω

Correct value without supply to the relay: ∞

ΩΩ

Ω

If the resulting values do not correspond to those

prescribed, replace the relay concerned.