User Guide
21
use and maintenance Habana 50/125 - Habana Custom 50/125
#/.42/,3/.4(%2)'(43)$%
/&4(%(!.$,%"!2
NOTE The electrical parts work only when the ignition switch
is in position “n”.
NOTE The lighting system works only when the engine is run-
ning.
1) LIGHT SWITCH (
o - p -
•
) (
_
J
not provided )
NOTE Before operating the light switch, make sure that the
dimmer switch (
a - b - a) is in position “b”.
When the light switch is in position “
•
”, the lights are off; when
the switch is in position “p”, the parking lights and the dash-
board light are on; when the switch is in position “
o”, the
parking lights, the dashboard light and the low beam are on.
The high beam can be operated by means of the dimmer
switch (
a - b - a).
2) ENGINE STOP SWITCH (
n - m)
aCAUTION
Do not operate the engine stop switch “n - m” in running
conditions.
This is a safety or emergency switch. With the switch in po-
sition “
n”, it is possible to start the engine; the engine can
be stopped by moving the switch to position “m”.
aCAUTION
With stopped engine and ignition switch in position “n”,
the battery may run down.
When the vehicle has come to a halt, stop the engine, and
move the ignition switch to position “
m”.
3) START PUSH BUTTON (
r)
When the start push button is pressed and one of the brake
levers (front or rear) is activated at the same time, the starter
makes the engine run.
For the starting procedure, see p. 34 (STARTING)