Owner`s manual

ELECTRICAL SYSTEM
5-5
En
g
ine 450 - 550
Select the measure unit and press SCROLL until it goes off.
The newly set value will be displayed after releasing the
button; to change it, proceed as described under “Changing
the values”. After confirming, wait until the symbol goes off.
Counter is reset automatically and the symbol goes off.
Press SCROLL briefly and End is displayed.
When End is displayed, press SCROLL briefly to go back to
the starting page.
Hold SCROLL pressed until dashes - - - - are displayed and
release to activate the test. The same result can be achieved
by turning the instrument off and on again.
Changing the values
Values can be set when the first digit on the left is flashing.
Press SCROLL within 2” to start setting. Each time SCROLL
is pressed, value increased by one unit. If SCROLL is not
operated within 2”, the second digit will be flashing. Set it
within 2” using SCROLL and proceed likewise for remaining
digits.
Once change is completed, the last digit on the left flashes
for 2” , then the value is stored and will not be displayed any
more.
If SCROLL is not operated, it will go off after the last digit on
the right has been flashing for 2”.
If necessary, setting operation can be repeated.