User Guide

22
use and maintenance RSV mille - RSV mille R
SETTING THE RED LINE THRESHOLD
(WITH ENGINE OFF ONLY)
When the maximum rpm set is exceed-
ed, the red line warning light LED “max”
(2) positioned on the dashboard starts
blinking.
If the push button j is pressed for less
than one second, the pointer of the revolu-
tion counter (4) shifts to the red line value
set for three seconds, after which it returns
to its initial position.
For the adjustment, proceed as follows:
◆ Press the push button j, release it and
press it j again within 3 seconds. The
pointer (4) moves increasing the value
by 1000 rpm at each click, as long as j
is kept pressed; when it has reached the
maximum value, it starts again from the
beginning.
◆ Press the push button j until the de-
sired rpm value has been set.
◆ If the push button j is released and then
pressed again within 3 seconds, intermit-
tently, the pointer (4) moves increasing
the value by 100 rpm at each click; when
it has reached the maximum value, it
starts again from the beginning.
NOTE It is not possible to set the red
line at values lower than 2000 rpm or high-
er than 12000 rpm.
aCAUTION
Never exceed the recommended rpm,
see p. 56 (RUNNING-IN).
◆ To confirm, release the push button j.
After three seconds, the red line thresh-
old setting is stored.
NOTE The setting is confirmed by the
coming on of the red line warning light LED
“max” (2).
RSVmille-R-UK.book Page 22 Friday, November 17, 2000 3:13 PM