User Guide

23
use and maintenance RSV mille - RSV mille R
MULTIFUNCTION (RIGHT DISPLAY)
The right display (multifunction) includes
the coolant temperature in °C (°F) (8) and
the digital clock (7) as standard settings.
NOTE When the engine is cold, the writ-
ing "9" blinks.
By pressing the push button g, the follow-
ing functions can be obtained in sequence:
STANDARD SETTING: COOLANT TEM-
PERATURE AND DIGITAL CLOCK
The coolant temperature value (8) is
shown in the upper part of the right display.
It is possible to switch from °C to °F and
viceversa, see p. 24 (SETTING °C OR °F).
– When the temperature is below 35°C
(95°F), the writing “9” (8) blinks on
the right display.
– When the temperature is over 115°C
(239°F), the value (8) blinks on the right
display, even if a function different from
the standard setting has been set.
– When the temperature is over 130°C
(266°F), the writing “
///” (8) appears
on the right display.
aCAUTION
If the writing “///” is displayed with a
temperature below 130°C (266°F), there
may be a failure of the electric circuit. In
this case, contact an APRILIA Official
Dealer.
Thermometer range on the display: 35–
130°C (95–266 °F).
The digital clock (7) appears in the lower
part of the right display. To set or modify
hour and minutes, see p. 24 (SETTING
THE HOUR) and (SETTING THE MIN-
UTES).
BATTERY VOLTAGE - VBATT
◆ If the push button g is pressed once, the
battery voltage expressed in volt (19) ap-
pears in the lower part of the right dis-
play, while the coolant temperature (8) is
displayed in the upper part. The writing
“V BATT” (20) is displayed. The re-
charge circuit functions correctly if at
4000 rpm the battery voltage with low
beam on is included between 13 and 15
V.
Standard setting: Temperature in °C
and digital clock
g
Battery voltage (V BATT)
g
Setting the hour
g
Setting the minutes
g
Setting °C or °F
SERVICEDIAG V BATT
8
7
SERVICEDIAG V BATT
19
20
RSVmille-R-UK.book Page 23 Friday, November 17, 2000 3:13 PM