User Guide

48
use and maintenance RSV mille - RSV mille R
02%,)-).!29#(%#+).'
/0%2!4)/.3
aWARNING
Before departure, always carry out a
preliminary checking of the vehicle to
make sure that it functions correctly
and safely, see the following table (PRE-
LIMINARY CHECKING OPERATIONS).
The non-performance of these checking
operations can cause severe personal
injuries or damages to the vehicle.
Do not hesitate to consult your aprilia Offi-
cial Dealer in case there is something you
do not understand about the functioning of
some controls or in case you suspect or
discover some irregularities.
It does not take long to carry out a check-
up and this operation ensures you much
more safety.
NOTE This vehicle is set so that any
anomaly can be detected in real time and
stored by the electronic unit.
Whenever the ignition switch is brought to
position “2”, the writing "
HIL" (1) appears
on the right side of the multifunction display
for approximately three seconds.
aCAUTION
If the writing “HIL” (1) is displayed
during the normal operation of the en-
gine, this means that the electronic unit
has detected an anomaly.
In many cases, the engine keeps run-
ning with reduced performance levels;
immediately contact an APRILIA Official
Dealer.
aCAUTION
After the first 1000 km (625 mi) and suc-
cessively every 7500 km (4687 mi), the
word "SERVICE" (2) appears on the
right display.
In this case contact an APRILIA Official
Dealer, who will carry out the operations
indicated in the regular service intervals
chart, see p. 60 (REGULAR SERVICE IN-
TERVALS CHART). To make the writing
“SERVICE” disappear, press the “LAP”
push button (3) and then the push but-
ton
r
(4) and keep them pressed for
about five seconds.
RSVmille-R-UK.book Page 48 Friday, November 17, 2000 3:13 PM