User Guide

DEALER INSTRUCTION SHEET DEALER INSTRUCTION SHEET

SCARABEO 50 i.e. SCARABEO 50 i.e.

Pag. 6

••

• Fit screws TCEI M 6x35 (6) of the wheel pin fork

clamp.

Screw (6) tightening torque: 8.85 ftlb (12 Nm).

••

• Fit the brake gripper with the screws TEF M 8x30

(2).

Screw (2) tightening torque: 16.96 ftlb (23 Nm).

SX DX

FITTING THE BATTERY

••

• Make sure the ignition key is in the “ ” position.

••

• Place the battery into its housing.

••

• First connect the positive cable (+ red) then the ne-

gative (- blue).

••

• Use a neutral grease or vaseline to grease terminals.

••

• Fit the tool tit holder and lower the saddle.

Pag. 3

FITTING THE MIRRORS

Before fitting the mirrors, check the threading of

the nuts with pilers: the right nut is left-threaded

and the left nut right-threaded.

••

• Tighten the nut with pilers M 8 (1) for the front brake

pump.

••

• Position the ring nut (2).

••

• Fit the mirror with rod and adjust as required.

Screw (1) tightening torque: 14.75 ftlb (20 Nm)

CAUTION

REDBLUE

IMPORTANT

••

• Fit the protective guard (3), as shown in the drawing.

Carry out the same operations for the left-hand

mirror.