Operator's Manual

Table Of Contents
Turn Conrmation Beep On/Off (BEEP)
After certain actions (e.g. pressing and holding a key) a
conrmation beep sounds. This conrmation beep can
be turned off.
1.Press the MENU key to open the menu.
2.Press the MENU key several times until BEEP and
the current setting ON or OFF is displayed.
3.Turn the volume control counterclockwise or
clockwise to change from ON to OFF or vice versa.
4.Press the MENU key several times to exit the menu.
KD34109,0000785-19-17JUL19
Adjust Maximum Volume at Power-On
(ONVOL)
The maximum volume when turning on the radio system
can be adjusted in the ONVOL menu. Basically, the last
selected volume is used at power-on unless it is above
the setting for the maximum volume at power-on. In this
case, the maximum volume setting is used.
NOTE: The maximum volume at power-on can be
adjusted from 5 to 25.
1.Press the MENU key to open the menu.
2.Press the MENU key several times until ONVOL and
the current setting is displayed.
3.Turn the volume control counterclockwise or
clockwise to adjust the maximum volume at power-on
from 5 to 25.
4.Press the MENU key several times to exit the menu.
KD34109,0000786-19-17JUL19
Adjust Sound
Adjust bass (BASS) and treble (TREB)
1.Press the AUD key to open the menu for the sound
settings.
2.Press the AUD key several times until BASS or
TREB and the current setting is displayed.
3.Turn the volume control counterclockwise or
clockwise to adjust the value from +7 to -7.
4.Press the AUD key several times to exit the menu.
Adjust middle (MID)
1.Press the AUD key to open the menu for the sound
settings.
2.Press the AUD key several times until MID and the
current setting is displayed.
3.Turn the volume control counterclockwise or
clockwise to adjust the value from +7 to -7.
4.Press the AUD key several times to exit the menu.
KD34109,0000787-19-17JUL19
Adjust Left/Right Volume Distribution
(BAL)
1.Press the AUD key to open the menu for the sound
settings.
2.Press the AUD key several times until BAL and the
current setting is displayed.
3.Turn the volume control counterclockwise or
clockwise to adjust the value from +10 to -10.
4.Press the AUD key several times to exit the menu.
KD34109,0000788-19-17JUL19
Adjust Front/Rear Volume Distribution
(FAD)
This adjustment is only available on vehicles with front
and rear speakers.
1.Press the AUD key to open the menu for the sound
settings.
2.Press the AUD key several times until FAD and the
current setting is displayed.
3.Turn the volume control counterclockwise or
clockwise to adjust the value from +10 to -10.
4.Press the AUD key several times to exit the menu.
KD34109,0000789-19-17JUL19
Turn Loudness On/OFF (LD)
Activating loudness improves the sound. The ratio of
low to high tones is changed to obtain an equalized
sound even at low volume settings. It is not
recommended to turn loudness on at high volume
settings.
1.Press the AUD key to open the menu for the sound
settings.
2.Press the AUD key several times until LD and the
current setting ON or OFF is displayed.
3.Turn the volume control counterclockwise or
clockwise to change from ON to OFF or vice versa.
4.Press the AUD key several times to exit the menu.
KD34109,000078A-19-17JUL19
Restore Sound Settings
All sound settings can be restored to the factory
settings.
General Operation - AM/FM Radios B
50-3