Installation and Operation Manual

NIS
5
Phone
Press the PHONE button (5) on the touchscreen to access the Uconnect phone
feature and connect a mobile device.
Backup Camera
Press the BACK CAM (6) button on the touchscreen to access the Backup
Camera Mode. This will allow you to utilize the vehicle’s backup camera
feature.
Vehicle
Press the VEHICLE (7) button on the touchscreen to enter the Vehicle Mode
and access the vehicle’s telematics information.
Settings
Press the SETTINGS (8) button on the touchscreen to access the Settings
Menu. The Settings Menu allows the user to change: Language, Display,
Background, Voice, Clock, Power Settings, Audio, Phone/Bluetooth, Radio
Setup, and Camera settings.
Compass
Press the COMPASS (9) button on the touchscreen to access the Compass
Mode and see the vehicle’s current direction.
Audio Settings
Press the AUDIO SETTINGS (10) button on the touchscreen to adjust the audio
Balance/Fade, Equalizer, Speed Adj Volume, and Loudness.
Regulatory Information USA
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including interference
that may cause undesired operation.
RF exposure safety
This device complies with FCC RF exposure limits and has been evaluated in
compliance with mobile exposure conditions.
The antenna must be installed and operated with minimum distance of 20 cm
between the radiator and your body.
Class B device notice
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of
the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.