User's Manual
Unable to trigger flash.
Ensure enough battery power.
Set the transmitter and receiver to the same channel and zone settings are correct.
Make sure the transmitter and receiver are set to the correct mode (TX/RX or RX).
Make sure the hot shoe mount or PC cable are completely connected.
Make sure the speedlite or strobe flash are compatible with TP2.
Make sure recycle time of your flash is ready.
Unable to fire the shutter.
Ensure enough battery power.
Set the transmitter and receiver to the same channel.
Make sure zone settings are correct to control multiple cameras.
Make sure the transmitter and receiver are set to the correct mode (TX/RX or RX).
Make sure the hot shoe mount or shutter cable are completely connected.
Make sure the camera settings are right.
Some black exists in the photo.
Max Sync Shutter speed is limited by the camera.
Flash isn’t ready to recycle when fire the shutter.
Camera shoots but doesn’t focus.
Make sure lens focus made is set to AF, not MF.
Operating distance limited.
Check if the battery is exhausted.
Try to move transmitter’s location.
Remove obstacles between the transmitter and receiver.
Adjust the position of antenna.
Try using 'SUPER' mode.
Mistakes happen when triggering or shooting due to interference.
Try other channels or zones.
8. Trouble Shooting
(The instruction and information in this manual are based on strict, controlled company testing
procedures. Further notice will not be given if the design and specifications change.)
15
AP-013II II 2.4G -2013LOGO
Friday, May 31, 2013 2:08:00 PM