User's Manual

4. Function and Operation
Triggering
7
8
Note:
1. For flashes that use PC cable should be inserted in TP2's 'CAMERA/PC' port.
2. To use studio strobes, connect flash sync cable with receiver's 'FLASH' port. 1/4"
adapter is necessary for most studio strobes.
1) Remote Flash Triggering
1. Place one unit on camera hot shoe or connect with camera by PC cable and
set to TX/RX.
2. Place one unit on remote flash and set to RX.
3. Press camera shutter button, remote flash will be fired.
4. Works the same way with studio strobes.
2) Local Flash Triggering
1. Place TP2 on flash and set to TX/RX.
2. Connect camera to TP2 by PC cable.
3. Press camera shutter to fire flash.
Controlling speedlite flash Controlling studio strobe flash
Indicator Lights
TX/RX TX/RX
RX
Operation
Mode
Transmitter Receiver
Remote
Shutter
Control
Half press
Trigger Button
Light green Light green
No indicator
Full press
Trigger Button
Blink red once Blink red once No indicator
Long press
Trigger Button 3s
Light red for 3s
Light red(Light
off once press
it again)
No indicator
Half press camera
shutter button
Light green
No indicator
Light green
Full press camera
shutter button
Blink red once No indicator Blink red once
Short press TEST
Button
Blink red once No indicator Blink red once
Normal
Low Battery
Power
Operation
Triggering
Switch to ON Blink green once/2s
Blink red once/2s
Switch to SUPER Blink green twice/2s
Blink red twice/2s
State
Idle
AP-013II  II 2.4G  -2013LOGO
Friday, May 31, 2013 2:07:59 PM