Operating instructions

TABLE OF CONTENTS
2
SECTION ITEM PAGE
1 Safety Precautions ....................................2
2 General Instructions ..................................4
3 Description ................................................4
4 Installation .................................................4
5 Thermostat Calibration..............................5
6 Operating ..................................................5
7 Maintenance..............................................6
SECTION ITEM PAGE
8 Cleaning ....................................................6
9 Specifications ............................................7
10 Wiring Diagrams........................................8
11 Troubleshooting Guide .............................10
12 Suggested Temperature & Times .............11
13 Replacement Parts ..................................11
14 Warranty...................................................17
APW Wyott takes pride in the design and quality of our products. When used as intended and with proper
care and maintenance, you will experience years of reliable operation from this equipment. To ensure best
results, it is important that you read and follow the instructions in this manual carefully. Installation and start-
up should be performed by a qualified installer who thoroughly read, understands and follows these
instruction.
If you have questions concerning the installation, operation, maintenance or service of this product, write
Technical Service Department APW Wyott Foodservice Equipment Company, P.O. Box 1829, Cheyenne,
WY 82003.
1. SAFETY PRECAUTIONS
Before installing and operating this equipment be sure everyone involved in its operation is fully trained
and is aware of all precautions. Accidents & problems can result by a failure to follow fundamental rules
and precautions.
The following words and symbols, found in this manual, alert you to hazards to the operator, service
personnel or the equipment. The words are defined as follows:
DANGER: This symbol warns of imminent hazard which will result in serious injury or death.
WARNING: This symbol refers to a potential hazard or unsafe practice, which could result in
serious injury or death.
WARNING: Check the data plate on this unit before installation. Connect the unit only to the voltage
and frequency listed on the data plate. Connect only to 1 or 3 phase as listed on the data plate.
WARNING: Electrical and grounding connections must comply with the applicable portions of the
national electrical code and/or other local electrical codes.
WARNING: Disconnect device from electrical power supply and place a Tag Out-Lockout on the
power plug, indicating that you are working on the circuit.
CAUTION: This symbol refers to a potential hazard or unsafe practice, which may result in minor or
moderate injury or product or property damage.
CAUTION: These models are designed, built, and sold for commercial use. If these models are
positioned so the general public can use the equipment make sure that cautions, warnings, and
operating instructions are clearly posted near each unit so that anyone using the equipment will use
it correctly and not injure themselves or harm the equipment.
NOTICE: This symbol refers to information that needs special attention or must be fully understood
even though not dangerous.
XXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXX