R CA UT ION HO T ION UT CA INSTALLATION AND OPERATING INSTRUCTIONS T HO 56 0 Model: VCG VERTICAL CONTACT BUN GRILL TOASTER INTENDED FOR OTHER THAN HOUSEHOLD USE RETAIN THIS MANUAL FOR FUTURE REFERENCE TOASTER MUST BE KEPT CLEAR OF COMBUSTIBLES AT ALL TIMES ! FOR YOUR SAFETY: Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.
IMPORTANT FOR FUTURE REFERENCE Please complete this information and retain this manual for the life of the equipment. For Warranty Service and/or Parts, this information is required.
TABLE OF CONTENTS SECTION 1 2 3 4 5 6 7 8 9 10 11 12 ITEM ........ PAGE Owner’s Information General Info. Warranty Info. Important! Safety Information Specifications Electrical Dimensions Operation .. Operating Instructions Temperature Adjustments Cleaning ....
2. SAFETY INFORMATION APW Wyott toasters are designed, built, and sold for commercial use and should be operated by trained personnel only. Clearly post all CAUTIONS, WARNINGS and operating instructions near each unit to insure proper operation and to reduce the chance of personal injury and/or equipment damage. Always disconnect power before servicing the toaster. Surfaces will remain hot after power has been turned off. Allow unit to cool before cleaning or servicing.
DIMENSIONS CAUTION HOT 23.90” 22.644” 560 POWER 20.44” 20.88” 21.77” CAUTION HOT 10.05” 13.
4. OPERATION Operating Instructions This toaster is for Dry operation only (no oil). Do not put buttered bread products in the toaster. ! ! ! Ensure Release sheets are properly installed. (See page 9.) Turn Main Power Switch on. Set Temperature Control to desired temperature. (Temperature is factory set at 600°F.) Allow Pilot Light to cycle at least two times (on/off). When the light is on, the grill is heating. Heat up time is about 15 minutes.
5. CLEANING Cleaning Instructions Toaster is for DRY BUNS ONLY. Do not put buttered bread products in the toaster. Figure 1 Diagram Note: To save time at closing (it will take 15 minutes for toaster to cool down), you might want to have the day shift clean the toaster. 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. 15. Turn off (7) Main Power Switch (See Fig. 1). Allow toaster to cool down. Remove (6) Bun Slide and (1) Top Cover (See Fig. 1.) and wash in sink. For ease of cleaning, rotate toaster.
CLEANING (EN ESPAÑOL) El Procedimiento de Limpieza Tostador es SOLO PARA LOS BOLLOS SECOS. No ponga los productos de pan unta dos con mantequilla en la tostadora.
Release Sheet Replacement 1 2 3 4/5 6 7 8 9/10 1. Turn toaster off. 2. Remove the top cover. 3. Remove old release sheet from the toaster platen (grill).!!! CAUTION !!! TOASTER PLATEN MAY BE HOT. 4. If the reverse side of the release sheet is still good, then fold the release sheet the opposite way and use the other side. Skip to step 6. 5. If using a new release sheet, fold the release sheet in half (length-wise) and firmly crease it. 6. Turn toaster on.
Problem No heat and conveyor belts don’t move. Possible Cause Corrective Action Toaster is installed incorrectly. Lid not placed on top securely. Manual High Limit switch tripped open. No heat and conveyor belts move. Defective components or wiring problem Temperature Controller Solid-state relay failure Inoperative Platen or Wiring Problem Set-point is too low Platen is hot and conveyor belts don’t move Product or silicone belt jammed Wiring problems, loose of broken drive chains. Conveyor hung up.
Possible Cause Problem Corrective Action Crown and / or heel must be forced into the toaster. Release sheet and / or silicone belt need cleaning. Bun Chute improperly installed. Toaster is overheating or cooling fan is not turning properly. Toaster making noise or unusual sounds. (Note that some noise is inherent to the normal operation of the toaster and does not requi re field service. If unsure, call the APW Wyott technical service department.
7. PREVENTATIVE MAINTENANCE SCHEDULE Tools required: Daily: Heat Resistant Gloves, Standard Cleaner, Standard Sanitizer, Soft Towels. Monthly: Needle Nose Pliers, Soft Brush Yearly: Phillips Screwdriver, Standard Lubricating Oil 1) Preventative Maintenance - Daily WARNING! Toaster may be hot. Allow to cool before cleaning. Use heat resistant gloves when removing the top cover, cleaning the Release Sheet, and cleaning the silicone belt. A. B. Exterior.
3) Preventative Maintenance - Monthly WARNING! Toaster may be hot. Allow to cool before cleaning. Use heat resistant gloves when removing the top cover, cleaning the Release Sheet, and cleaning the silicone belt. A. In addition to the daily cleaning described above, remove and clean silicone belt. Remove the top cover and bun chute and clean with detergent in a sink. Open one of the side panels (front or rear) exposing the orange silicone belt.
5) Preventative Maintenance Yearly A. In addition to the daily cleaning described above, remove the silicone belts according to the instructions described in (3), and inspect the metal conveyor chain. Check the tension to make sure that drive sprockets are engaging all the wires in the metal conveyor chain.
8. WIRING DIAGRAM - VCG TOASTER 5 4 Manual Limit Sw. N.C. 2 SSR 1 3 Relay 4 + Cooling Fan 8 Element Limit Sw. N.C.
9.
ITEM NUMBER 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 Not Shown 20 21 22 23 24 25 26 27 28 29 30 Not Shown 32 33 34 35 36 37 38 39 40 41 42 PARTS LIST - VCG TOASTER PART NUMBER 85640 89111 81600204 81600223 81600284 81600025 81600282 81600214 81600226 81600227 81600249 81600266 81600100 89488 81600296 85281 81600101 81600065 81600294 81600220 81600295 81600235 81600277 81600210 81600212 83267 81600105 81600255 81600103 81600050 81600321 86285 69146 69147 30218 81600311 81600322 81600248 81600337 816003
PROCEDURE FOR BELT ADJUSTMENT (TRACKING) Position yourself so that you face the conveyor with the access cover between you and the conveyor. The platen should be on the other side of the conveyor from you. This puts the adjustment screw on your right. Start No Continue to monitor the conveyor from time-totime for a couple of days to see if it walks over a sprocket.
12. APW WYOTT EQUIPMENT LIMITED WARRANTY APW Wyott Foodservice Equipment Company warrants it's equipment against defects in materials and workmanship, subject to the following conditions: This warranty applies to the original owner only and is not assignable. Should any product fail to function in its intended manner under normal use within the limits defined in this warranty, at the option of APW Wyott such product will be repaired or replaced by APW Wyott or its Authorized Service Agency.
Phone: Fax: Toll Free: Website: E-mail: (214) 421-7366 (214) 565-0976 (800) 527-2100 www.apwwyott.com info@apwwyott.
