Specifications

26
OPTIONAL
Standard Power Center
To Indoor
Control Panel
120 VAC
240 VAC
English/Metric
Jumper
AquaRite
Control
Jand
y
A
q
uaLink RS
4-pin Connector
AquaRite
®
Chlorine Generator Installation
Installation Instructions:
The Jandy AquaLink RS and AquaRite use a 4-wire connection to communicate and can be wired up to 500' apart. Any
outdoor rated 4 conductor cable can be used.
Locate appropriate screw terminals on the circuit board according to the diagram below (screw terminals are removable
to aid in installation).
IMPORTANT: attach wires to like numbered screw terminals on both the AquaRite
®
and AquaLink RS. Use a Multiplex Kit
if more than two items are connected to any 4-pin connector.
PPD Tool
Back View of Bezel Assembly
Power Center Printed Circuit Board
(Back of Power Center Board used with Pool/Spa combo unit only)
Alignment
Arrow
Pry Slots
Beveled Corner
Using the PPD tool,
pry out the PPD evenly
on both sides.
Spare AUX
Programmable
Peripheral Device
Spare Aux -
This socket has power only when the Filter Pump is
on and the pool water is circulating. It has no power
when the system switches to "Spa". It is used on a
pool/spa combination system when the user wishes
to turn off a piece of equipment (such as the
chlorine generator) while the spa is being used.
NOTE: DIP switch 6, in Rev. I software, changes this
operation to Spa mode
Power Center PPD Removal: