Specifications

7
Basic Plumbing
Booster Pump Pool Cleaner Plumbing.
If you are using a Booster Pump Pool cleaner, plumb the
booster pump so its suction side is connected to the
pool return after the heater and as close to the ground
as is practical (see diagram to the right). Please note
that the installation of a booster pump pool cleaner
requires moving DIP Switch #1 to the ON position.
Solar System Plumbing
Booster Pump Plumbing
Solar System Plumbing.
If a solar system is part of the equipment, plumb the solar
feed and return lines between the main filter and the
heater (see diagram to the right). Please be sure to make
provision for solar drain down. Use a Jandy Non-Positive
Seal Valve to provide drain down. Plumb in a solar
booster pump if needed.
NOTE: A Jandy (10K) Solar Sensor will be needed for
solar system control. The sensor should be located near
the solar panels and connected to the Power Center by
18 AWG wire.
If a solar booster pump is installed, follow the
wiring diagram on page 34 for more information.