Specifications
8
• Light Dimming (12 VAC and 120 VAC)
1000 Watts incandescent
Power Center Connection - High Voltage
Mount Power Center.
All electrical equipment, except for the Four Function Switch, must be five feet or more from pool /spa and comply with all
national, state and local codes. If using a Jandy Power Center without built-in breaker compartment, install electrical supply
panel with separate breakers for each load. Make sure that motors on equipment have built-in thermal protection. Use the
grounding terminal, provided within the Power Center, for grounding. Bond all equipment, including the Power Center, to
earth ground. (Install to provide drainage for all electrical components.) Mount no less than 5 feet from pool/spa and at least
5 feet off the ground. In areas where lightning strikes are common, install an external surge suppression device.
Run Conduit/Wire from Supply Panel.
Depending on the amount of equipment you want to control, run ¾" or larger conduit from the power supply panel to the
lower side of the Power Center. If you are using the Power Center with built-in breaker compartment, wire power to the
appropriate breakers. Pull in appropriate wire for equipment. Each piece of equipment requires its own high voltage relay.
Connect 120 volts to the power supply terminals. Connect equipment ground(s).
Wire Relay (install additional relays if needed).
For each piece of 240 volt equipment to be controlled, wire line power to the two line terminals of a Relay and wire
equipment to the two load terminals. For each piece of 120 volt equipment, wire power to a line terminal and the equipment
to a load terminal. Order and install optional relay modules if additional equipment is to be installed. Wire all relays and feed
the relay plugs through the holes into low voltage compartment. Plug in relay coils using the wiring diagram on page 34 as
a guide.
Special Relays.
If you have a two-speed pump, you must order and install a two-speed relay. If you wish to install light dimming, you must
order and install a light dimming relay.
Contact Ratings: Do not exceed any rating.
• Standard Relay
3 H.P. at 240 VAC
1 ½ H.P. at 120 VAC
25 Amps
1500 Watts
• Two Speed
2 H.P. at 240 VAC
1 H.P. at 120 VAC
20 Amps