Use and Care Manual

ManualsBrandsAqua-Pure ManualsWater equipment3MFF100

Installation and Operating Instructions For

Full Flow

Drinking Water System

Model: 3MFF100

Installer: Please leave manual with homeowner.

System tested and Certiﬁ ed by NSF International

against NSF/ANSI Standard 42 and 53 for the

reduction of the claims speciﬁ ed on the

Performance Data Sheet and against CSA B483.1.

INSTR2214 0412.indd i 4/6/2012 9:56:24 AM

Summary of content (8 pages)

PAGE 1
Installation and Operating Instructions For Full Flow Drinking Water System Model: 3MFF100 System tested and Certified by NSF International against NSF/ANSI Standard 42 and 53 for the reduction of the claims specified on the Performance Data Sheet and against CSA B483.1. Installer: Please leave manual with homeowner.
PAGE 2
PAGE 3
SAFETY INFORMATION Read, understand, and follow all safety information contained in these instructions prior to installation and use of this Full Flow Drinking Water System Model 3MFF100. Retain these instructions for future reference. Intended use: The Full Flow Drinking Water System is intended for use in filtering potable water in homes and has not been evaluated for other uses. Model 3MFF100 is installed at the point of use and typically installed under a sink.
PAGE 4
PRODUCT SPECIFICATIONS Flow Rate: 2.5 gpm (9.5 lpm) Pressure: 25 - 125 psi (172 - 862 kPa) Temperature 40 - 100°F (4.4 - 37.8°C) Capacity: 6,000 gallons (22,712 liters) GETTING STARTED • Installation requires some household tools and additional plumbing components. Parts and Materials Required for 3MFF100 Undersink Installation (Included): 1. Filter Head Assembly 2.
PAGE 5
IMPORTANT INSTALLATION INSTRUCTIONS The following installation instructions described are based on copper plumbing with 3/8” compression fittings. Additional fittings may be required to connect to cold water supply. 1. Open faucet and turn off cold water supply to relieve pressure. 2. Select and mark a location under the sink that allows access for filter change. You will be connecting to the existing line with 3/8” tubing and various fittings not supplied with this filter assembly. 3.
PAGE 6
12. Align lugs of filter with head assembly and insert filter into head assembly. Turn filter to the right (clockwise) until it stops (about 1/4 turn). The filter is now installed. (See Figure 6) OUTLET 13.Turn on cold water supply valve and open faucet to flush air from the system. Run water for a minimum of 4 gallons (approximately 2 minutes) to flush system. INLET 14. Close the faucet. The system is now ready for use. System is now under pressure and can be inspected for leaks.
PAGE 7
LIMITED WARRANTY 3M Purification Inc. warrants this Product will be free from defects in material and manufacture for one (1) year from the date of purchase. This warranty does not cover failures resulting from abuse, misuse, alteration or damage not caused by 3M Purification Inc. or failure to follow installation and use instructions. No warranty is given as to the service life of any filter cartridge or membrane as it will vary with local water conditions and water consumption. 3M PURIFICATION INC.
PAGE 8
3M Purification Inc. 400 Research Parkway Meriden, CT 06450, U.S.A. Tel (800) 222-7880 (203) 237-5541 Fax (203) 238-8701 www.3Mpurification.com www.aquapure.com 3M is a trademark of 3M Company. Aqua-Pure is a trademark of 3M Company used under license. NSF is a trademark of NSF International. © 2012 3M Company. All rights reserved. Please recycle. Printed in U.S.A.