Owner`s manual

6
1. Preparation of the spa for filling: Remove the cover and remove the skimmer filter.
2. To fill the spa, place the tip of a hose in the compartment vacuum skimmer filter and fill the tub until
the upper jets are submerged. Be careful not to overfill.
CAUTION: Never completely fill your spa with water from a water softener. Use anti-scale
treatment to prevent limestone deposit. Eventually you can fill the spa halfway with water
"hard" and the other half with softened water.
IMPORTANT: Always fill the spa through the filter compartment after having emptied. This
facilitates priming pumps
3. Powering: Using the circuit breaker of the house, put the spa under tension. After a brief test ( can
take upto 5mins ) of its devices, the spa will display the spa water temperature.
4. Activation of pumps: Activate each of the pumps, one after the other, ensuring that each is primed
and water is flowing.
5. If a pump does not boot automatically turn on and turn off several times in succession until it begins.
If this is unsuccessful, unscrew the panel cladding, which is under the keyboard and slightly loosen the
relevant pump bleed screw ( see photo below ) to bleed to vent air trapped in the pump. Once the air
is exhausted, tighten the screw, the pump is primed.
screw
6. Adding chemicals : add chemicals recommended by your dealer. See section 11.0 Water treatment
for general guidance.
7. Setting the temperature of the spa to heat the water at a comfortable temperature, follow these
steps:
-The display indicates the actual temperature of the spa water. Press once the button "cool" or "warm"
to the desired temperature (or setpoint) is displayed for a few seconds. If you want
change the water temperature, simply press "less" or "more" until the desired temperature is
displayed.
-The heater will stop once the temperature setpoint is reached.
Important Information on the heater:
· The maximum temperature of the spa is 40 ° C and minimum temperature is 26 ° C.
· For the heater to work, you need only pump 1 working on speed 1. Turn off the pump 2 if it is turned
on.
. Setting the thermostat at maximum will not accelerate the warming of the spa. Only the final
temperature will be higher.
· The heater operates until the set temperature is reached, then turns off. It will restart when the water
temperature is 0.5 ° C below the set temperature.
DANGER: Risk of burns! Check the water temperature before entering in the spa!
Do not leave under any pretext the spa unattended while the cover is open and it is accessible to
young children or pets.