Owner`s manual

SITEPRE PARATION
Becauseyournew spais portable,youcanlocateitjustaboutanywhereyouwishona
patio,onadeck,int hemiddleofyouryard,orevenindoors.Justbesuretopositionit
abovegroundinalevelled areawithgooddrainage.Ithasto supporttheweightofthe
spawhenfilled withwaterandpeople.
· Itisresponsibility,of thespaowner,tomakesurethatthespaisonasolid,
level,andappropriatesurfaceorbase.
· Placethespaonatleast1012cm ofsoliddryconcrete.Donotplacespaon
wetornotcompletelydryconcrete,whichmaytendtosinkorsaganddamagethespa
andwillvoidyourwarranty.Makesurethattheconcreteisleveled.
· Ifthespaistobeplacedonawooddeckorpatiobesurethatthewood
structureisableto hold theweight.
· Placingyourspaona bedofpeagraveloronadirtsurfacewilldamageyour
spa,voidingyourwarranty.
· Makesureany wooddecking doesnothaveanylowspots,highspots,orany
gapsbetweenthesurfaceandthebottomofthespa.Thiswillcausedamagetoyour
spaandwillvoidyourwarranty.
· Ifanydamageisdonetoyourspadueto thesurfaceonwhichthespais
placedthewarrantywillbevoided.
ELECTRICALREQUIREMENTS
IMPORTANT:WheninstalledintheEU,theelectricalwiringofthespamust
meettherequirementsofthegivencountry.Theelectricalcircuitmust be
installedbyanelectricalcontractorandapprovedbyalocalbuilding/electrical
inspector.
Itisthecustomer’sresponsibilitytoacquirenecessarypermitsandtoarrangefor
installationandconnection to electricalpower supply byalicensedelectrician.
Correctwiringoftheelectricalservicebox,GFCIboxandpacktermi nalblockis
essential.
Connect iont othepowersupply
IMPORTANT:
Carefull yreadthisparagraphbeforeconnectingthecontroller! Failureto
observetheinstructionscontainedinthisparagraphmaycauseseriousdamageto
thecontrollerandtotheotherelectricaldevicesinstalled.
Thepowercableshouldbeconnectedtothemainpowersupply.
TheMICROSPAcontrollercanbeconnectedto powersupply:
Singlephase:230V,50/60Hz,15A
Allmodelsmustbepermanentlyconnected(hardwired)andGFCIprotectedin
accordancewithlocalandnationalelectricalcodes.Allelectricalwiringmustbe
performedbyalicensedelectrician knowledgeableintheoperationandwiringofa
GFCIprotectedsystems.
AquaSpa Owner´sManual, page9
INSTAL LATIONPROCEDURE
· Werecommendthatyouleavesomespaceopenaroundyourspa toallowforeasy
accessfromallsides,making anymaintenanceeasier.
· Fillthespawiththewaterfromthehose throughthefilterinlet(afterfillingis
complete,remembertoputthefi ltercartridgeinplacepriortostartingthespa). Thisway
youminimisethechancesoftrappingairintothepumpsystem. Thewaterlevelshould be
halfwayupthefilterarea.
· Neverallowthewaterleveltodropbellowtheskimmeropening.Airwillenter into
waterlines system,causingproblemswith thewaterflow.Runningthepumpwithout
waterflowwilldamagethepumpsealassemblyand couldresult in furtherequipment
damage.
INSTALLINGPOWERTHROUGHTHESPACABINET
· Openthefrontpanellocatedunderkeypad.
· Openthecontrol headpaneltorevealtheterminalblocks.
· Runcablefromtheopeningonthebottomofthespathroughtheplas ticpipeinto
thecontroller.
· Connectpowercabletotheter minal.
· Makesurethewiresare intheircorrectpositions beforeturningthepoweron
· Oncethespaiswiredinmakesureallwater knifevalvesareaopen.
Donotrunspawit hvalvesclosed,thiscoulddamagethespaequipment.
STARTI NGFORTHE FIRSTTIME
Beforeswitchingthecontrolleronforthefirsttime, makesurethat:
· thereissufficientwaterinthepool;
· allthe valvesareopen;
· thereisnothingthatcanblocktheflowofthewaterin thepipes.
Generally,whenstartingforthefirsttime,t hetemperatureofthewaterintroducedinto
thespa shouldbelowerthanthetemperaturesetpoint( 35°C).For Thisensuresthatonce
thespaisstartedup thecontrollerwillactivatethepumpt osendwatertotheheater.
AquaSpa Owner´sManual, page10