Owner`s manual

11
CONTROL PANEL OPERATION
INITIAL START-UP - When your spa is first powered up it will go into priming mode, indicated
by “Pr”. The priming mode will last
for less than 5 minutes and then the
spa will begin to heat and maintain
the water temperature when in the
Standard mode. Your spa has been
designed so that it will automatically
heat the water to the factory set
temperature of 100°F unless you set
the spa to a different temperature. If power is disconnected from the spa, it will automatically
revert back to the factory set Temperature of 100°F when power is reapplied.
TEMPERATURE ADJUSTMENT (80°F-104°F)
Can only function between 80°F - 104°F / 26°C - 40°C. The last measured temperature will
constantly display on LCD.
Press the Up or Down buttons to display the set temperature. Each time either button is pressed
again, the set temperature will increase or decrease depending on which button is pressed. After
three seconds, the LCD will automatically display the current spa temperature.
JETS OPERATION
Firmly press the Jets button once to activate the low speed of the pump and again for the high
speed. Firmly press the Jets button again to turn off the pump. If left running the low speed of the
pump will automatically turn off after 4 hours. The high speed pump will automatically turn off after
15 minutes. The low speed of the pump may also activate for at least 2 minutes every 30 minutes
to detect the spa temperature and then to heat to the set temperature if needed, depending
upon mode. When the low speed turns on automatically it cannot be deactivated from the panel:
However the high speed may be started.
LED MULTI COLOR LIGHT (VERONA & TRANSPORT™ MODELS ONLY)
Press the Light button once to turn on the light. Press the button again to turn the light off. Every
time the light is quickly turned off and back on, a new color will illuminate. There are 6 different
colors followed by a color wheel. The color wheel starts out as a white light. Exiting the color
wheel may require you to press the light button quickly 4 times or more.
NOTE: The blue color is the first of the 6 colors followed by the color wheel. If left on, the light will
automatically turn off after 4 hours of operation.
LIGHT (NEWPORTER & TOSCANO MODELS ONLY)
Press the Light button once to turn on the light. Press the button again to turn the light off.
OPERATIONAL MODE:
The Standard Mode is the default operational mode preset from the factory. In order to program
the spa to operate in the other 2 modes allowing you to change the mode, dip switch #7 on the
control box board must be moved downward into the "off" position (See page 9).
If your spa has been modified to allow mode change, press the Up or Down button, then while the
display is flashing press the light button to go into Standard, Economy or Sleep Mode.