Specifications

ManualsBrandsAquacal ManualsHeat PumpAeroTemp 155

Important

Read This Guide Before Installing or Operating Heat Pump

LTP0074 Rev 4 11/11/2014

Heat Pump

Quick Start Guide

Models: 035, 055, 075, 090, 115, 110, 120, 121, 135, 155, 156, & 175

For product manuals and further installation / operation procedures

visit www.AquaCal.com

Summary of content (6 pages)

PAGE 1
Heat Pump Quick Start Guide Models: 035, 055, 075, 090, 115, 110, 120, 121, 135, 155, 156, & 175 For product manuals and further installation / operation procedures visit www.AquaCal.
PAGE 2
Page 1 SECTION 1 - GENERAL INFORMATION CONTACTING AQUACAL AUTOPILOT Web www.AquaCal.com (727) 823-5642 8:00 a.m. to 5:00 p.m. Eastern time, Monday through Friday Phone Fax (727) 821-7471 Please have your model and serial numbers available when contacting AquaCal AutoPilot for questions, service, or parts. SAFETY For personal safety, and to avoid damage to equipment, follow all safety instructions displayed in this guide.
PAGE 3
Page 2 SECTION 2 - INSTALLATION For commercial or complete installation instructions please, visit www.AquaCal.com for equipment manual. EQUIPMENT CLEARANCES Keep the area immediately adjacent to the heat pump clear of items such as shrubs and bushes, lawn furniture, chemicals containers, etc. These items can prevent air from circulating properly through the heater, and will result in inefficient operation and/or damage to the heat pump.
PAGE 4
Page 3 SECTION 3 - OPERATION Pool Spa Cooling POOL SPA Desired Temp Water Temp Heating ° 78 DOWN UP MODE Figure 4 INDICATOR LIGHTS LIGHTS EXPLANATION “Pool” Pool Thermostat Selected “Spa” Spa Thermostat Selected “Cooling” “Desired Temp” “Water Temp” “Heating” Actively Cooling Water SUPPLEMENTAL INFORMATION Not applicable for Straight Heat models.
PAGE 5
Page 4 PROGRAMMING Activity Steps Adjusting Temperature Step 1: Select the “POOL / SPA” button to choose the thermostat to adjust. Step 2: Select the “UP” or “DOWN” button to increase or decrease the desired set temperature. Step 3: Once set, the current water temperature will be displayed. The Heat Pump will start to operate to meet the desired temperature. Please note a time delay will be experienced if Heat Pump has just been initialized. This delay is between 4 to 5 minutes.
PAGE 6
Page 5 SECTION 5 - TROUBLESHOOTING While troubleshooting in cooling mode indicators may fluctuate. Always troubleshoot in heating mode. ERROR CODES SYMPTOM RULE OUT RESOLUTION "FLO" Insufficient water flow through heater or circulation pump is off Insufficient Water Flow Step 1: Confirm water pump is on and water valves are in the correct position to allow water to flow through Heat Pump. If error persists, proceed to next step. Filtration Dirty Step 2: Confirm filtration system is clean.