Manual

4
Assembly
HAND HELD TRANSMITTER
❏ 1. After removing the transmitter and transmitter antenna
from the box, line up the antenna to the hole in the top of the
transmitter. Slip the antenna in and lightly screw the antenna
into the transmitter. Do not over tighten. Give the antenna a
light tug to make sure it is properly installed.
❏ 2. Slide off the battery door from the bottom of the transmitter.
❏ 3. Install 8 “AA” batteries into the transmitter in the
confi guration molded into the battery fl oor.
❏ 4. Reinstall the battery door onto the bottom of the transmitter.
❏ 5. Turn the transmitter “ON” using the switch on the
transmitter’s left side. The battery level indicator light (LED)
should glow green. If the light is fl ashing the batteries are low
and need to be replaced.
RECEIVER BATTERIES
❏ 1. Using a #1 Phillips screwdriver (small), remove the two
(2) Phillips head screws from the top of the radio box. One is
located under the front seat of the boat and the other behind
the back seat.