User Manual

ManualsBrandsAquacraft ManualsHobbyBoat RC Aquacraft Gunslinger P-27 RTR

aquacraftmodels.com

WARNING

Never attempt to swim after a stalled R/C boat.

Never operate your R/C boat while standing in the water.

Never operate your R/C boat in the presence of swimmers.

Always use a Personal Flotation Device (PFD) when boarding and operating your

retrieval craft, i.e. Jon boat or duck boat. NOTE: Because of the sharp running

hardware included with this R/C boat, we do not recommend a rubber blow up raft.

R/C boat running hardware is very sharp. Be very careful when working on and around

the metal parts.

While the motor is running, pay close attention to the propeller. Do not come in contact

with the propeller at any time the engine is running or serious injury will result.

AquaCraft products are to be used by ages 14 and over.

INSTRUCTION MANUAL

Summary of content (8 pages)

PAGE 1
aquacraftmodels.com INSTRUCTION MANUAL WARNING Never attempt to swim after a stalled R/C boat. N Never operate your R/C boat while standing in the water. N Never operate your R/C boat in the presence of swimmers. N AAlways use a Personal Flotation Device (PFD) when boarding and operating your retrieval craft, i.e. Jon boat or duck boat. NOTE: Because of the sharp running re hardware included with this R/C boat, we do not recommend a rubber blow up raft. R/C boat running hardware is very sharp.
PAGE 2
Introduction IMPORTANT LIPO PERFORMANCE AND CARE Thank you for purchasing the AquaCraft P-27 Gunslinger! We want the time you spend with your new RC boat to be fun and successful so please fully read the manual. If for any reason you think this model is not for you, return it to your local dealer immediately. NOTE: Your hobby dealer cannot accept a return on any model after final assembly or after your boat has been subject to operation.
PAGE 3
BOAT FEATURES: ● Tactic TTX240 2.4GHz transmitter with TR325 receiver ● 1800kV brushless in runner motor ● Never, ever attempt to swim after a stalled RC boat. ● LiPo ready (3S) 50 Amp brushless motor controller with Do not get in the water for any reason to retrieve your low battery stutter warning system and battery cut off boat. To aid you in retrieving a stalled RC boat set up circuit. a fishing reel with a tennis ball tied to the end of the ● Tough, lightweight ABS construction with square hatch line.
PAGE 4
Transmitter To help you better understand your transmitter and its functions, here is a picture outlining the operational features. 1. Steering Wheel 2. LED power on indicator 3. Power ON/OFF button 4. Throttle trigger 5. Steering rate adjustment (this is used to increase or decrease the turning radius of the boat) 6. Throttle reversing switch (“R” is the position the switch needs to be in for your P-27 Gunslinger) 7. Throttle Trim dial (this should be in the 2:00 o’clock position) 8.
PAGE 5
3. Install the battery pack by using the provided hook and loop. 4. Plug the battery into the motor controller. Arming 4. Now is a good time to check that the rudder turns the correct way. Turn the wheel right (Clockwise) and the rudder should turn right. Turning the wheel left (CWW) and the rudder should turn left. Running Your P-27 Gunslinger 1. Turn on your transmitter. 2. Plug the battery pack into the motor controller. 3.
PAGE 6
IMPORTANT: If you should happen to strike anything in the water the rudder is designed to “kick back”. To return your rudder to the running position simply rotate the rudder blade forward until it snaps in place. Tuning Your Gunslinger If your boat takes on a large amount of water and stalls in the middle of the lake, don’t worry, your P-27 Gunslinger has foam floatation so it will not sink. You will however have to retrieve the boat and remove the canopy to remove the any water that might have entered.
PAGE 7
6. Test for proper Tx/Rx functionality by completing the next section. If it doesn’t seem the radio has linked properly, repeat steps 1-6 above. One more thing we would like to point out about your P-27 Gunslinger Crackerbox. The prop shaft is offset on the bottom of your hull. It looks crooked, and it is offset, but this is done intentionally as it helps control torque from the prop and motor.
PAGE 8
FCC Statement This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions. (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation. NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT.