2 Stage Stingray RO Instruction & Owner’s Manual 7208 Aloma Ave Suite 600 Winter Park, FL 32792 Phone 407-599-2123 Fax 407-599-2124 www.Aquariumwaterfilters.com www.AquaFX.
7208 Aloma Ave – Suite #600 – Winter Park, FL 32792 1-877-256-3467 www.AquaFX.net STINGRAY INSTALLATION INSTRUCTIONS Congratulations on your new AquaFX Stingray water treatment system. There are a few basic steps about the installation and maintenance of your water treatment system. If you should have any difficulties or questions, please do not hesitate to contact us and we will be happy to help you any way we can. We recommend you hook your RO unit to a softened water supply.
Temperature Compensation Table 80 70 Gallons per Day 60 50 40 Series1 30 20 10 0 0 20 40 60 80 100 Temperature in Degrees F The Series 1 curve demonstrates the effect temperature has on the permeate flow of a 50 Gallon per Day (GPD) membrane. The above curve was generated by varying the water temperature.
Aqua Engineering & Equipment, Inc. Returned Goods Policy Damaged Merchandise: Aqua Engineering & Equipment, Inc. cannot be held liable for damage to or loss of a shipment by any carrier. Claims for damaged products, suspected damages, container shortages, or pilferage within the container on delivery must be noted on the delivery receipt. The carrier’s claims representative should then be notified immediately. Returned Goods: Aqua Engineering & Equipment, Inc.
Limited 3 Year Warranty Aquarium & Home Water Treatment Systems This unit is of exceptional quality, hereby warrants equipment to its first purchaser at retail as follows; This warranty covers filter cartridge housings, fittings and tubing and all components. Filter replacements including sediment cartridges, carbon block cartridges, DI cartridges and Reverse Osmosis membranes are the responsibility of the consumer. Exceptional water conditions are NOT covered. Potable water supplies ONLY.
Filter Change Sheet and Normal Operation Note: Filters are referenced in the order in which they appear in the system 1. Sediment Filter: This filter is first in line; removes particles that can be physically filtered out. An example of a particle that would be removed is sand. This filter’s life depends on the amount of particles in your water. The best gauge of this filter’s life is pressure drop. When you see a 5PSIG drop, you should change your filter.
Trouble shooting guide Problem High TDS after membrane Solution Clogged Pre-filters. Causing Pressure Drop. Insufficient pressure will yield poor TDS rejection from RO membranes. Change Pre-Filters. Average Membrane life is 2 to 3 years. Most common cause for membrane failure is insufficient pre-filter maintenance. AquaFX Carbons are rated for 3,750 gal @ 1.0 GPM of 2ppm Chlorine. Do not exclude drain water from this capacity, as it is treated water.
