Goliath Drain Pan Installation Instructions

Rev. 10/08
2. Install the drain housing from inside the pan MAKING SURE THE RUBBER GASKETS ARE ON THE INSIDE OF THE PAN. (fig. 9)
3. Screw the nut onto the drain housing from outside the pan and securely hand tighten. (fig. 10)
(fig.10)
(fig. (9)
4. Install the Float Switch onto the Drain Housing by inserting flat plastic slide into the corresponding receptacle on the housing. (figs. 10,11,12)
Slide Down & insert Switch in to the Drain Housing to connect Switch & Housing
(fig. 11) (fig. 12) (fig.13)
.
6. Position the switch at the desired height and hand tighten the height adjustment wheel. Make adjustments with the height adjustment wheel and float sensitivity
slide. (figs. 14, 15)
(fig. 14) (fig. 15)
PLUMBING:
(To ensure proper performance of product, instructions must be followed.)
Run the condensate lines, if required, in accordance with applicable codes.
WIRING the AG-4100, AG-4200 & AG-4300:
Threaded Nut
Drain Housing
Threaded Nut
Drain Housing
Height Adjustment Wheel
Adjust slide to raise &
lower float sensitivity
Rubber
Gasket