Owners manual
Installaon Manual
AquaJet Pro Medium Output Solar Pump Kit
AquaJet-Pro-Kit-12V-MedOutput-V4
Silicon Solar
2917 State Hwy 7
Bainbridge, MY 13733
P: 1.800.786.0329
www.SiliconSolar.com
Copyright 1997 - 2015 Silicon Solar | All Rights Reserved | Version 1.0.0
* Prices and specicaons subject to change without noce
3. Assembly Instructions
1. Unpack all components carefully.
2. For the application of pumping water for a water feature or water fall,
connect the pump outlet to the water inlet of a garden water
decoration or the headstream of your water fall with the attached soft
water hose.
3. For the application of creating a small spraying up fountain, just fix
the pump at the bottom of a basin or a small shallow pond etc, and
fit the nozzle on the top of the pump tube. The nozzle can produce 2
different jet shapes. It is best to keep the pump off the pond base to
avoid drawing the pond waste into the pump, which will lead to
blockage in the pump. Use a brick or similar to elevate the pump. To
produce excellent fountain effect, please leave the fountain head
above the water surface by using the extension tubes. If these 4pcs of
extension tubes are all used and the pump head is still immerged in
the water, please uplift the pump body somehow.
4. Electrically connect the pump to the solar panel, and tighten the
protection screw.
5. Install the solar panel in garden lawn or soft ground by jabbing the
spike into the ground. Adjust the orientation of the panel to face the
panel towards the sun and then tighten the screw on the back of the
panel.
6. Make sure to keep the pump fully submerged in water while the
pump is in operation.
7. The solar pump is now ready to operate.
4. Cautions
1. Any altering of the product itself or changing of
the components voids warranty.
2. Do not connect the pump to any AC power
supply directly, it’s ONLY for DC power.
3. All the connectors are protected against reverse
polarity as shown in the right figure. Don’t insert
the plug with reverse polarity by using
unnecessary force.
4. Operate the pump in water only (never above
40C), especially keep it away from flammable
liquids.
5. Do not strike the solar panel.
5. Cleaning And Maintenance
If the pump starts losing power or stops working after operating for a certain time, please clean the pump following the steps below
(See the above figures for demonstration):
1. Disconnect the pump.
2. Press on the bottom of the filter housing and meanwhile move the filter housing apart form the pump.
3. Turn the impeller cover together with flow valve clockwise to the end and then carefully pull the impeller cover together with
flow valve apart from the pump.
4. Remove the impeller wheel from the pump.
5. Wash every part to clean the debris.
6. Assemble the pump in reverse sequence.
7. Connect the pump.
*Be careful, never drop down the
ceramic axis while cleaning the
impeller, it breaks easily.