User`s manual

36
Change Engine Oil
YOU MUST CHANGE ENGINE OIL:
• After First 10 Hours Operation
• According To Maintenance Schedule In Section 4
• After Your Powerboard Capsize A Couple Of Times
• When Water Gets Into Engine Through Carburetor, Exhaust System Or Engine
Breathing Hose.
STEPS TO CHANGE ENGINE OIL:
1) Oil drain plug is located at the bottom of hull beneath engine. Make sure that engine
is off and warm, but NOT HOT.
2) Place your watercraft on a trailer or a lifting equipment so that you can access to the
bottom of hull. Make sure the engine is leveled.
3) Use a proper oil pan to collect used oil to protect environment. Place it under the
access window to the engine oil drain plug.
4) Use the special wrench tool (supplied) to open the access window to engine oil drain
plug at bottom of hull. Keep the “O” ring for later use.
5) Use a 17mm socket wrench to open oil drain plug. There is a washer, a spring, oil
filter screen and a magnet came out with the oil drain plug. Put oil filter screen and
magnet in a cleaning container.
6) Drain dirty oil completely.
7) Clean oil filter screen and magnet.
8) Re-install back magnet, filter screen, washer and oil drain plug.
9) Close the access window cover. Make sure the “O” ring is in good condition and fit
into the cover.
10) Fill new engine oil to the right oil level.
CAUTION:
• Make sure the drain plug is properly secured after oil change. No oil leak!
• Make sure the access window is properly sealed with “O” ring and properly secured.
No water leak!