User`s manual

BREAK-IN PERIOD

Your craft is equipped with a 4 stroke closed loop water cooled engine. Having a

breaking-in period is crucial to its proper performance and the product life. The

engine break-in period allows various components of the engine to wear and polish

themselves to the correct operation clearances and conditions. The scheduled oil

change during the break-in period is also required. It will prevent excessive wear and

damage to the components.

Failure to perform the required break-in period may significantly handicap your craft

performance, shorten the product life. In certain circumstances, it may void your craft

warranty.

CAUTION:

• Explicitly follow the instructions of this section. Failure to do so may reduce the

engine’s life and/or performance. With the 4 stroke closed loop water cooled engine,

a break-in period of 10 hours is required before continuous operation at full throttle.

To achieve a good break-in, throttle lever should not be depressed more than 3/4,

however, brief acceleration and speed variations contribute to a good break-in.

• Continued wide open throttle runs and prolonged cruising without speed variations

should be avoided, this can cause engine damage during the break-in period.

YOU MUST CHANGE ENGINE OIL, REPLACE OR CLEAN OIL

FILTER AND MAGNET AFTER FIRST 10 HOURS OPERATION

BY AN AUTHORIZED AQUANAMI DEALER!

STEPS TO CHANGE ENGINE OIL:

1) Oil drain plug is located at the bottom of hull beneath engine. Make sure that engine

is off and warm, but NOT HOT.

2) Place your watercraft on a trailer or a lifting equipment so that you can access to the

bottom of hull. Make sure the engine is leveled.

Before operating your Powerboard, read this User’s Manual thoroughly,

fully understand how the craft works, become familiar with all controls

and functions. Consult your Aquanami Dealer for any questions about

control and operation you may have. Failure to do so could cause

damage to your watercraft and an accident!

WARNING