User`s manual

48
Armpole for jetSurf
Armpole provides support to operator during operation. It also houses control cables
and electric wires. Having a damage free and fully functioning Armpole is important to
your safety as well as other waterway users.
CAUTION:
Check the Armpole housing looking for cuts, tears or any other kind of damage. Ensure
that the Armpole housing is securely connected to the housing anchor and the handle. The
Armpole should remain securely attached to the jetSurf when the handle is pulled.
Additionally ensure that there are no loose and/or missing screws. If the Armpole sustains
any damage consult your Aquanami Dealer.
Damage to the Armpole, Armpole housing and/or the handle can result
in SEVERE INJURY OR DEATH.
WARNING
Exhaust Pipe Cooling
CAUTION:
To ensure it is properly working, check by-pass outlet. Water mist/drops
should come out exhaust by-pass outlet. If the exhaust from the by-pass is not wet, stop
engine and consult your Aquanami Dealer.
• The exhaust pipe is cooled by the water from the jet pump. If the
water flow from jet pump to exhaust pipe is blocked, the exhaust
pipe and connecting components could be damaged.
• Close and tight the exhaust flush cap (garden hose connector cap)
after flushing exhaust system.
• Exhaust system will be burned, damaged or caught fire if the
exhaust flush cap left open!
WARNING
CAUTION: Never run the engine without supplying water to the exhaust cooling system
when watercraft is out of water. If out of water, level the craft. Install a garden hose to the
flushing connector. Refer to POST-OPERATION CARE and follow the procedure.
CAUTION: Failure to flush exhaust cooling system, when engine is out of water, may
severely damage the exhaust system.
CAUTION: Never run engine longer than 1 minute when watercraft is out of water.
Drive line seal has no cooling when watercraft is out of water.
!
!