User`s manual

59
Certain components in the engine compartment may be very hot. Direct
contact may result in skin burn. Do not touch any electrical parts or jet
pump area when engine is running.
WARNING
CAUTION:
• Never flush a hot engine.
• Always start the engine before opening the water tap.
• Open water tap immediately after engine is started to prevent overheating.
• Never run engine without supplying water to the exhaust cooling system when
watercraft is out of water.
• Never run engine longer than 1 minute. Drive line seal has no cooling when watercraft is
out of water.
• Close the water tap, then stop the engine.
• Always close the water tap before stopping the engine.
• Ensure to install the connector cap back after flushing
The user should not start water flow into flush water connector until the engine is
started; adding that running water into the flush system without the engine first running
will result in engine damage that will not be covered under warranty.
Anticorrosion Treatment
To prevent corrosion, spray a corrosion inhibitor (salt water resistant) over metallic
components in engine compartment. Apply dielectric grease (salt water resistant) on
battery posts and cable connectors.
!