User`s manual

A weed clogged area can be cleaned as follows:

Stop engine and remove the Lanyard from its post to prevent accidental engine starting

before cleaning the jet pump area. Manually remove the weeds, shells or debris from drive

shaft and jet. Start engine and make sure watercraft operates properly. If system is still

blocked, move the watercraft out of the water and remove blockage manually.

CAUTION: Inspect water intake grate and impeller for damage. Refer to an authorized

Aquanami dealer for repair as necessary.

Always remove the Lanyard from its post to prevent accidental engine

starting before cleaning the jet pump area. Leave safety lanyard on its

post will drain battery dead when engine is not running.

WARNING

Capsized Watercraft

If watercraft turns over, it will remain capsized. When watercraft is capsized, do not

attempt to restart the engine.

Operator should always wear approved personal flotation devices. To return the

watercraft upright, ensure the engine is off and the Lanyard is NOT on its post.

• In shallow water, lift one side of the watercraft to upright.

• In deep water, lean your body on one side and grab the other side of watercraft, then use

your body weight to rotate the watercraft in any direction.

• The bilge pump should automatically start to drain water in bilge. If the water sensor

failed to start the bilge pump, push the bilge pump switch to drain the water in the bilge.

CAUTION:

• If watercraft has been capsized for LESS THAN 3 minutes, wait until the bilge pump stop

working. Then start the engine.

• If the watercraft has been capsized for MORE THAN 3 minutes, check bilge first. If bilge

has less than 3 inches of water, wait until the bilge pump stop working or manually turn

on the bilge pump if the water sensor failed to turn on the bilge pump. Then start the

engine.

• If the watercraft has been capsized for MORE THAN 3 minutes, and the bilge has more

than 3 inches of water, wait until the bilge pump stop working or manually turn on the

bilge pump if the water sensor failed to turn on the bilge pump. Drain the carburetor bowl

first by loosing carburetor drain screw, and drain the fuel water separator bottle by pulling

off the hose from middle nipple of the bottle to drain contaminated fuel. Then start the

engine.