User`s manual

General Inspection

Check engine compartment for any damage and for leaks of fuel, coolant or oil. Ensure

all hose clamps are properly secured and no hose is cracked, kinked or presenting any other

damage.

If any gasoline leak and/or odor are present, do not start the engine.

Have the watercraft serviced by an authorized Aquanami dealer.

WARNING

Inspect muffler, battery and fuel tank. Visually check electrical connections for

corrosion and tightness. Inspect hull and jet pump water intake grate for damage.

Replace or have damaged parts repaired.

Cleaning

The bilge should be cleaned to remove any fuel/oil/electrolyte deposits and

mildew. Occasionally, wash the body with water and soap (only use mild detergent).

Remove any marine organisms from engine and/or hull. Apply non-abrasive wax such

as silicone wax.

CAUTION: Never clean fiberglass and plastic parts with strong detergent,

degreasing agent, paint thinner, acetone, etc.

Lubrication and Anticorrosion Protection

Throttle Cable

Lubricate the throttle cable with XP-S Lube or equivalent. Depressing and releasing

the throttle lever should operate smoothly. Throttle lever should return to its initial position

without any hesitation. There must be a small amount of free-play when throttle lever is

released. Refer to an authorized Aquanami dealer if necessary.

Electrical Connections

As necessary, apply anticorrosion product such as dielectric grease on battery posts and

all exposed cable connectors. Additional Lubrication XP-S Lube or equivalent will help

prevent corrosion of metallic parts and maintain proper operation of moving mechanisms.

• Do not alter or tamper with throttle cable adjustment or routing.

• If throttle lever does not automatically return, do not operate watercraft

and see your authorized Aquanami dealer.

WARNING