User`s manual

69
Steering System
Check steering mechanism to ensure steering operates smoothly, and no excessive lash
in the system.
Propulsion System
Remove the Lanyard from its post to prevent accidental engine starting before
inspecting and cleaning the jet pump area. Inspect impeller, intake grate, ride plate, to see
any damage. Inspect all fasteners. Clean and lubricate for corrosion prevention. Refer to
Post Operation Care.
Automatic vacuum siphon pump uses a low pressure area in the jet pump to siphon the
water out of the bilge when the engine is operating. Inspect the pump head for obstructions,
clean as necessary.
Inspect and replace sacrificial anode if equipped.
Hull
Inspect hull for cracks and any possible leaks. Check all seals in good conditions.
If the circuit breaker is opened, source of malfunction should be
determined and corrected before reset. See an authorized Aquanami
dealer or servicing.
WARNING
STORAGE
If any repairs are needed to body or to the hull, contact your authorized Aquanami
dealer. Apply a good quality marine wax to the body. If the watercraft is to be stored outside,
cover it with an opaque tarpaulin to prevent sun rays and grime from affecting the plastic
components, watercraft finish as well as preventing dust accumulation.
CAUTION: The watercraft should never be left in water for storage. Never leave the
watercraft stored in direct sunlight. Never store watercraft in a plastic bag.
!