HEAT PUMP POOL HEATER BOMBA DE CALOR PARA PISCINAS OWNER'S MANUAL MANUAL DEL USUARIO PRO400, PRO600, and PRO1000 101 Production Drive, Harrison, OH 45030 877.278.2797 fax 877.289.2963 cs@aquaprosystems.com www.aquaprosystems.
Operating Instructions Please read and save these instructions. Read carefully before attempting to assemble, install, operate or maintain the product described. Protect yourself and others by observing all safety information. Failure to comply with instructions could result in personal injury and/or property damage! Retain instructions for future reference. Contents Important Safety Instructions . . . . . . .2 • The water in a pool or spa should never exceed 104ºF (40ºC).
PRO400, PRO600, PRO1000 Installation Procedures Unit Inspection Inspect your unit very carefully before installing. Make sure there has been no damage to the evaporator fins or there are no punctures or oil-soaked areas on the box. This would indicate damage to the refrigeration system and should be rejected immediately. 5’ Minimum in. M ” 18 18” Min. THE UNIT MUST BE TRANSPORTED IN THE UPRIGHT POSITION AT ALL TIMES AND MUST NOT BE DROPPED OR TAILGATED.
Operating Instructions Figure 3 - PRO400 & PRO600 Wiring Diagram Basic Heat Pump Operation See Figure 3 for wiring schematic of PRO400 & PRO600. See Figure 6 for wiring schematic of PRO1000. Electrical Connections Connecting to Remote System (PRO1000 only) All wiring and ! WARNING electrical connections must be performed by a qualified electrician. Installations must be in accordance with local and national codes. Overheating, shortcircuiting and fire damage will result from inadequate wiring.
PRO400, PRO600, PRO1000 Figure 6 - PRO1000 Wiring Diagram Manual Temperature Controls Description PRO400 & PRO600 • The manual Temperature Control is designed to regulate pool and spa water temperature. • There are two indicator lights on the control panel to display the current status of the unit. • The thermostat knob may be adjusted to maintain the desired water temperature. that power to the unit is on. The RED light indicates that the unit is in heating mode.
Operating Instructions Application Guidelines (Continued) Pool Blankets Pool Openings If you decide to rinse down the evaporator coils yourself, disconnect all power to the entire equipment pad before you rinse it. This must be done in order to prevent possible electrical shock. A pool blanket has been proven to greatly reduce the heat loss in the pool and will save as much as 50% - 60% in your heating bills.
PRO400, PRO600, PRO1000 LIMITED WARRANTY For five (5) years from the date of purchase for the PRO400, PRO600 & PRO1000, Wayne Water Systems, d/b/a AquaPro Systems (“AquaPro”) will repair or replace, at its option, for the original owner any parts of its Heat Pumps (“Product”) which are found upon examination by AquaPro to be defective in materials or workmanship. For the Pro 1000 you are covered by a ten (10) year warranty on the compressor, which is prorated from years six (6) through ten (10).
Manual de Instrucciones Sírvase leer y guardar estas instrucciones. Lea con cuidado antes de tratar de armar, instalar, manejar o darle servicio al producto descrito en este manual. Protéjase Ud. y a los demás observando todas las reglas de seguridad. El no seguir las instrucciones podría resultar en heridas y/o daños a su propiedad. Guarde este manual como referencia. Índice Importantes instrucciones de seguridad . . . . . . . . . . . . . . . . . . . .14 Química de la Piscina y Garantía . . . .
PRO400, PRO600, PRO1000 Guías de seguridad (Continuación) la hipertermia incluyen: desconocimiento del peligro inminente, falta de percepción del calor; falta de reconocimiento de la necesidad de salir de la piscina o de la tina, incapacidad física para salir de la piscina o de la tina, daño al feto en mujeres embarazadas, e inconsciencia que puede tener como resultado el riesgo de ahogo. • Mínimo 5 pies (1,5 m) Mín.
Manual de Instrucciones Motor del ventilador Sensor de Temperatura Negro Anaranjado Azul Presión baja Negro Transformador de 240V-24V Rojo Rojo Nuet Azul Azul Termostato Amarillo Azul Negro Retraso Azul Marrón/blanco Línea Línea Interruptor automático Amarillo Marrón Presión alta Gris Negro Amarillo Cal. En. Sal.
PRO400, PRO600, PRO1000 Motor del ventilador Sensor de Temperatura Presión alta Línea Línea Azul Retraso Negro Azul Anaranjado Azul Presión baja Negro TERMOSTATO DEL HIDROMASAJE Amarillo Azul Compresor Nuet TERMOSTATO DE LA PISCINA Cal. En. Sal. Nuet Cal. En. Sal. Azul Amarillo Gris Luz roja Blanco El Calentador de Piscinas PRO1000 es compatible con todos los sistemas remotos conocidos de la industria de piscinas.
Manual de Instrucciones retardo. No gire la perilla del termostato durante este tiempo de retardo. Si gira la perilla durante este ciclo se podría reiniciar el tiempo de retardo, provocando que la unidad demore cinco minutos adicionales antes de comenzar a funcionar. Punto de ajuste de la temperatura del agua • El rango del punto de ajuste de la temperatura es de 45ºF a 107ºF (7ºC a 42ºC).
PRO400, PRO600, PRO1000 Guía de diagnóstico y resolución de problemas Si el calentador no está funcionando durante el encendido inicial, verifique para ver si se ha instalado correctamente, según este manual del propietario. Asegúrese de que el disyuntor se haya medido correctamente.
Manual de Instrucciones GARANTÍA LIMITADA Durante 5 (cinco) años a partir de la fecha de compra del PRO400, PRO600 y PRO1000, Wayne Water Systems, cuyo nombre comercial es AquaPro Systems (“AquaPro”) reparará o cambiará, a su propio criterio, para el propietario original, cualquier pieza de sus bombas de calor (“Producto”) que AquaPro determine, luego de examinarlo, que tienen defectos de materiales o de mano de obra.
PRO400, PRO600, PRO1000 Notes Notas 1-877-AQUASYS 15
Operating Instructions Manual de Instrucciones PRO400, PRO600, PRO1000 Notes Notas 1-877-AQUASYS 16