Instructions / Assembly

For Use With Cold Water Only.
NOTE:Removeitemsfromunderthesink.Placecatchbasintheretocollectsmallamountsofwaterthatmayrunout
when disconnecting water supply lines.
1. Turnoffcoldwatersupplyvalveandremoveexistingwater
supplytubingand/orfitting.
2. Selectandmarkalocationunderthesinkthatallowsaccess
forfilterchange.
3. Usingfilterhead/bracketasaguide,fastenFilterHead
Assembly to wall with #2 Phillips mounting screws supplied.
 Markholelocationssothatthereis11/2”betweenthe
screws(seeFigure1),fromcenterofeachscrew.When
installed,filterbottomshouldbeatleast21/2”fromsink
cabinetfloortofacilitatecartridgechange.Installscrews,but
onlyhalfway,soyoucaneasilyslipthebrackettowallbefore
firmlysettingscrews.
4. Determinelengthoftubingrequiredfromfilterhead/bracket
tofaucetandfromwatersupplylinetofilterhead/bracketby
holdingtubinginplaceensuringitisofappropriatelength.
Donotkinktubingasthiswillimpedewaterflow.Ifneces-
sary,looptubingaroundtoavoiditbeingkinked.
 Cuttubingstraightwithautilityknife.(SeeFigure2).
5. Installfaucetadapterfittingtofaucet.Thisshouldbeasnug
fit.Do not overtighten.(SeeFigure3)
Correct Incorrect
Figure 2
To Release Tubing
Push in grey collet to release tubing. With collet
held, pull tubing straight out.
Collet
Backstop
“Using Push-In Fittings”
To Attach Tubing
Push tubing in as far as it will go. Tubing must be inserted
past o-ring and hit backstop. Pull tube to ensure it is secured.
I
nstall F
a
ucet
Ad
apter
Fi
tt
i
n
g
Figure 3
INSTALLATION INSTRUCTIONS
Figure 1
CAUTION
To reduce the risk associated with property damage due to water leakage:
 • Ensurealltubingandttingsaresecureandfreeofleaks.