Use and Care Manual

18
W
W
a
a
t
t
e
e
r
r
C
C
h
h
e
e
m
m
i
i
s
s
t
t
r
r
y
y
(
(
C
C
o
o
n
n
t
t
i
i
n
n
u
u
e
e
d
d
)
)
It is recommended that the spa be drained regularly depending on its size, location and the frequency of use.
1. Clean filter and cartridge periodically according to manufacturer’s instructions.
2. Keep the spa covered when not in use to reduce the loss of heat and to keep our leaves, dirt, and other
foreign materials from settling in the water.
3. Since the water capacity of your spa is far less than that of a swimming pool, the chemical reaction caused by
the presence of one or more persons in the spa is more rapid and pronounced. For these reasons, it is
important to frequently check the bromine level, the pH level and total alkalinity of water then add the
prescribed chemicals as necessary to maintain the proper chemical balances.
4. If questions or doubts arise regarding quantities and timing or chemical applications to your spa, contact your
spa dealer who can assist you in prescribing the correct program for your spa.
5. Store all chemicals in a cool dry place and in such a manner as to prevent contact by children and pets.
6. When adding chemicals to your spa water, add to the center of the spa with the pump operating. Never add
chemicals to unheated water as this will affect chemical action.
Replacing the LED light.
1. Turn off power to the spa.
2. Using a Philips screwdriver, remove the access vent located on the outside of the spa, directly behind the
filter (Fig 7.1).
3. Reach in and turn the white holder counter clockwise and gently pull it, with the attached wires, out the
access hole (Fig 7.2).
4. Pull the LED light out of the light socket (Fig 7.3).
5. Install a new LED light, attach the white reflector turning clockwise and reattach the access vent with the
screws.