Manualshelf

Use and Care Manual

ManualsBrandsAquaRest Spas ManualsOtherAR-600P 6-Person Spa with Ozone, Heater and 19 Jets in Stainless Steel, and LED Waterfall in Brownstone (240-Volt)
12345678910
10
H
H
U
U
2
2
S
S
y
y
s
s
t
t
e
e
m
m
O
O
p
p
e
e
r
r
a
a
t
t
i
i
o
o
n
n
Initial Start-Up
When your Spa is first activated, it will perform a self diagnostics test showing a series of numbers followed by Pr, then by -
-along with the low speed pump for approximately 7 minutes total. Also the internal clock that keeps track of the filtration
cycles every 12 hours will start at that point. The system is preset to heat up to 100° F (37° C) and it is also preset to run on
low speed for two hours (F2).
Temperature Adjustment
70° F-104° F (21°C-40° C)
When either of the temperature pads or are pressed once, the LCD will display the temperature witch has been
set. Each time either one of this pads are pressed again, the temperature will change by 1°, After 5 seconds, the LCD will
automatically display the current spa temperature.
Jets
Press the pad to run the pump on and off. If left running, the high speed pump will automatically turn off after 30
minutes or low speed in two hours. Time out duration can be adjusted. See page 17 for details.
Light
Press the pad to turn the spa light on. To switch color modes, press the pad again immediately after turning it off. If
left on, the light will automatically turns off after four hours.
Spa Water Maintenance
This function enables you to program the amount of water filtration time.
Press or and to enter the programming mode.
Once in the programming mode press or to select the filtration time.
F2 In this mode the water will be filtered for 2 hours every 12 hours.
F4 In this mode the water will be filtered for 4 hours every 12 hours.
F6 In this mode the water will be filtered for 6 hours every 12 hours.
F8 In this mode the water will be filtered for 8 hours every 12 hours.
FC In this mode the water will be filtered continuously.
To exit press .
Standby Mode (SY)
This function allows you to disable the equipment when the filter requires service without disturbing programmed
filtration time.
Press repeatedly (or hold it down) until it gets to 70° F (21° C) then press it one more time (within a couple of
seconds) to enter the stand by mode. All spa functions are disabled except for freeze control. To exit from standby press
any button and re-enter desire set temperature.
For additional features and display messages, see next pages.
1 0 2
XXX-HU2-XX-X