Manualshelf

Use and Care Manual

ManualsBrandsAquaRest Spas ManualsOtherAR-600P 6-Person Spa with Ozone, Heater and 19 Jets in Stainless Steel, and LED Waterfall in Graystone (240-Volt)
12345678910
9
S
S
y
y
s
s
t
t
e
e
m
m
O
O
p
p
e
e
r
r
a
a
t
t
i
i
o
o
n
n
Initial Start-Up
When your Spa is first activated, it will perform a self diagnostics test showing a series of numbers followed by Pr, then by -
-along with the low speed pump for approximately 7 minutes total. Also the internal clock that keeps track of the filtration
cycles every 12 hours will start at that point. The system is preset to heat up to 100° F (37° C) and it is also preset to run on
low speed for two hours (F2). If after the first 7 minutes water is not flowing from the jets you may need to purge the
pump. Please see page 21.
Temperature Adjustment
70° F-104° F (21°C-40° C)
When either of the temperature pads or are pressed once, the LCD will display the temperature which has been
set. Each time either one of this pads are pressed again, the temperature will change by 1°, After 5 seconds, the LCD will
automatically display the current spa temperature.
Jets
Press the pad to power the pump. The pump will sequence with each press of the pad as follows: low flow – high
flow – off. If left running, the high flow pump will automatically turn off after 30 minutes (low flow in two hours). These
time out durations can be adjusted. See page 14 for details.
Adjustable LED Light
To turn the light on, press the button. Press again to turn it off. To adjust the color modes, press the button
immediately after turning it off. The light will come back on in a new color mode. Each time you repeat this procedure,
the light will cycle to a new color mode, as shown below. If left on, the light will automatically turn off after four hours.
1. Color wheel. The light will slowly blend cycle
through the colors.
2. Aqua white.
3. Light blue.
4. Violet.
5. Dark blue.
6. Light green.
7. Dark green.
8. Red.
9. Step sequence through the colors.
10. Very slow color wheel.
11. Back to #1.
Spa Water Maintenance
This function enables you to program the amount of water filtration time.
Press or and to enter the programming mode.
Once in the programming mode press or to select the filtration time.
F2 In this mode the water will be filtered for 2 hours every 12 hours.
F4 In this mode the water will be filtered for 4 hours every 12 hours.
F6 In this mode the water will be filtered for 6 hours every 12 hours.
F8 In this mode the water will be filtered for 8 hours every 12 hours.
FC In this mode the water will be filtered continuously.
To exit press .
1 0 2