Use and Care Manual

PURGING THE PUMP

Sometimes after a water change (draining and refilling the spa), or initial start-up of the spa, there is no water flowing from

the jets. You may hear the pump operating or even see the shaft of the pump motor turning, but have no water flowing

from the jets. In addition to no flow out of the jets, you may even see an error message dr, dY, HH, OH, HL, or LF. All of

these error messages can be caused by a lack of water flow. When this happens there is probably an air-lock in the pump.

This air-lock must be purged from the plumbing for the pump to operate normally.

To purge the pump, please follow these steps:

1. Assure the spa is filled 6 to 8 inches (15 to 20 cm) below the top of the spa.

2. Remove the access panel to expose the water pump.

The pipes entering and leaving the pump are connected with large plastic unions. To purge the air from the pump, one

of these unions will be slightly loosened.

3. Place a towel under the union to be loosened.

4. Using large pliers, slightly turn the union nut counterclockwise (Fig 8). This will produce a faint hissing sound of the

trapped air escaping the pump. This will be followed by a small squirt of water which signals it is time to close the

union by turning it back (clockwise). Do not over tighten the union. It is designed to be hand tight.

Large Pliers

Plastic Unions

Fig 8

Tighten (close)

Loosen (open)