Installation Guide
10
9
Before pulling the liner up against the wall, insert a vacuum
cleaner hose down into the pump return hole to approxi-
mately 15 cm (6") from the ground.
Maintain the hose in place with adhesive tape. Don't forget
to block the skimmer hole with adhesive tape to prevent air
from leaking in. Place the unfolded liner in the center of the
pool area at right angles with the skimmer hole. Make sure
you wear light, at-soled shoes to walk on the sand as the
slightest heel mark could be visible once the pool is lled.
Hang the “U-Bead” liner on the top of the wall and install the
round stabilisers to secure.
At this point, the liner may be too ght, making it dicult to
drape the overlap or, on the contrary, too loose. In such
case, you will have to redistribute the tension in the liner by
removing some of the couplers and readjusng the liner.
Overlap
Carefully unfold the liner (U-Bead or Overlap), bringing the
boom-sidewall seam close to the wall base. Make sure the
side with the protruding seam faces downward or that the
paerned side faces upward.
U-bead
Li up a secon of the “Overlap” liner over the top of the
wall while adjusng the tension in the liner to enable
stretching of 1 to 2 inches in the wall. Secure the liner with
a plasc coupler.
15cm (6”)