Installation Guide
11
Fill the pool up to the base of the wall before stopping and
removing the vacuum cleaner.
PUMP RETURN FITTING
Aer you remove the vacuum cleaner, you may install the
return ng.
Place the return ng ring against the liner and adjust it so
that it is perfectly aligned with the hole in the wall.
When the ring is properly posioned and secured, cut the
liner in the middle of the ring.
Insert the return ng from the inside, placing the rst
gasket between the return ng and the liner and the sec-
ond between the wall and the liner. Then ghten the out-
side ring with large pliers, taking care not to crease the lin-
er.
BOTTOM DRAIN (oponal)
Find the holes through the middle of the liner and screw
the ring and gasket in against the liner before cung the
liner in the middle of the ring, then screw on the drain cov-
er.
10
Install the extension cap on top of each upright then install
metal screws at the top of the support posts, making sure
the support posts are perpendicular to the ground.