Installation Guide
AQ-5300+
Replacement cartridge:
AQ-5300+R
Rated service flow:
0.72 gpm (2.7 lpm)
Max capacity:
800 gallons (3,028 liters)
Min working pressure:
20 psi (1.40 kg/cm
2
)
Max working pressure:
80 psi (5.62 kg/cm
2
)
Min operating temperature:
40° F (4.44° C)
Max operating temperature:
90° F (32.22° C)
Do not use with water that is microbio-
logically unsafe or of unknown water
quality without adequate disinfection
before or after the system. Systems
certified for cyst reduction may be
used on disinfected waters that may
contain filterable cysts.
Pure Satisfaction
All Aquasana products oer a 90-day 100% satisfaction guarantee. A
one (1) year warranty is included, which covers defects in materials and
workmanship. If for any reason you are not satisfied with your purchase,
simply call us or the dealer you purchased from. A Return Authorization
Code and a full refund will be promptly issued upon return.
This filter system is designed and tested for use with genuine Aquasana parts, including
replacement filters and all hardware. Use of parts from other manufacturers may result in loss
of contaminant reduction performance, system damage or failure. Use of parts from other
manufacturers will also void your warranty. Please visit aquasana.com for all replacement parts.
Precautions:
• Slow Filter? Change pre-filter cartridge more often.
• Filter is only to be used with cold water.
• If you experience a leak at the hose connection, disconnect and re-seat the hose.
• Aquasana is not liable for consequential or incidental damages due to improper installation.
Care and Maintenance
To clean your filter unit, wipe down the exterior with a damp cloth.
Once filters are at 95% capacity (about every 6 months), the battery alarm will sound and flash red
when water is flowing and will continue for 15 seconds once water is turned o. Change the battery
every time you replace your filters. The battery is included with the filter replacement cartridges.
WARNING
Do not use tools to remove
or tighten sumps. Over
tightening can cause
damage and result in
leaking. Hand tighten only.
Remove each
sump from
the manifold
by hand.
Place
wrench
over sump
top and slide down.
Turn wrench
counterclockwise.
Continue turning
counterclockwise.
Remove top
and filter.