Use and Care Manual

ManualsBrandsAquasana ManualsKitchenPro Series Water Filter System with Scale Inhibitor Water Conditioning for Foodservice Applications

Installation and Operation Guide

High-Flow Pro Series Systems

Welcome to the Aquasana experience. You are about to provide your patrons

with clean, healthy water and the peace of mind that comes from knowing award

winning ﬁlter technology is working for you.

Installation must comply with state and local laws.

Summary of content (8 pages)

PAGE 1
Installation and Operation Guide High-Flow Pro Series Systems Welcome to the Aquasana experience. You are about to provide your patrons with clean, healthy water and the peace of mind that comes from knowing award winning filter technology is working for you. Installation must comply with state and local laws.
PAGE 2
Items that may be needed for installation • Wall anchors • Bucket • Teflon® tape • Pipe dope • Variable speed drill • Adjustable wrench • Drill bits • Measuring tape • Copper tubing • Propane torch • Solder • Level Standard Kits: 15.5” 22.25” 8” 9.75 lbs. 14” 15 lbs 8” 10 lbs 22.25” 26.38” 25 lbs 20.25” 20 lbs 22.25” 32.38” 30 lbs Warnings • Please read and understand entire manual before attempting to assemble, operate and install product.
PAGE 3
Long-lasting, high performance water filtration for great-tasting, healthy water throughout your entire establishment.
PAGE 4
Installation 1. Shut off water supply and select a mounting location a) The location should allow for a minimum clearance of 2 ½ inches under the cartridge(s) so they can be removed and replaced. b) Provide adequate space on both sides for plumbing and also for system flushing. 2. Install gauges provided onto manifolds as shown *Use Teflon® tape Note: Entry gauge goes on front pipe. Exit gauge goes on back pipe. 3. Install “T” fitting and drain shut-off valve onto outlet port ¾” NPT *Use Teflon® tape 4.
PAGE 5
. Plumb to connect 3/4” NPT connections a) Connect inlet + outlet ports of High-Flow Systems to water consuming equipment being fed. b) Use an industry approved pipe dope or Teflon® tape at all connections. c) Always use a wrench on all the fittings to avoid undue stress on system components. d) Careful when sweating joints not to damage elastomeric components. 6. Plumb to connect to beverage center if applicable a) Plumb to exit port of “H” Adapter if feeding water to a carbonated beverage products.
PAGE 6
Installation Guide Aquasana Pro Series systems are designed to be customized to fit your specific water usage requirements. Below is a general guide to the installation order for filtration cartridges. Based on your specific usage requirements, your system may not include all cartridges shown. If you have any questions about the installation order of your cartridges, please contact us at 855.245.1884 or proseriessupport@aquasana.com.
PAGE 7
Troubleshooting Guide Symptom Cause Action Too Low Incoming water valve not completely open Open incoming water valve to full open Too Low Clogged filter cartridge Replace filter cartridges Too Low Defective pressure gauge Remove and replace pressure gauge using Teflon® tape Cartridge Defective or damaged cartridge O-ring Remove and replace cartridge O-rings or replace filter cartridge Manifold Defective or damaged manifold O-ring Disassemble manifold and remove and replace manifold O-rings
PAGE 8
Aquasana, Inc. 6310 Midway Road Haltom City, Texas 76117 855.245.1884 www.aquasana.com For exclusive deals facebook.com/aquasana twitter.