Use and Care Manual
2
SYSTEM CONFIGURATION
2
If you have added components to your Rhino
®
Water Filter System,
note the correct sequencing below.
(Installation shown below includes Professional Grade Install Kit)
Before installing
• Lay out system in appropriate conguration. Improper sequence
of equipment will aect performance, and could possibly damage
your system.
• For all installations: Anticipate the need for additional parts and pieces
including but not limited to pex tubing, clamps and mounting screws to
install unit properly (available at a local home improvement stores or
through your plumbing contractor). Due to the varieties of home design,
not all congurations can be addressed in this guide.
• DO NOT install this lter where the line pressure may exceed 100 psi.
The operating pressure range for this lter is between 20psi – 100psi.
• Install on cold water lines only (40° – 90°F).
• Installation of the ltration system must comply with existing state and
local plumbing codes. Aquasana and its manufacturer are not liable for
consequential or incidental damages due to improper installation.
• DO NOT install the unit on its side. It must be installed upright
to maximize contact with media bed.
Salt-Free Water
Conditioner
(Optional)
Rhino
®
Water
Filter System
10" Post-Filter
(Optional)
10" Pre-Filter
(EQ-300 and
EQ-600 only)
20" Pre-Filter
(EQ-1000 and
Pro Kit only)
UV Filter
(Optional)