Use and Care Manual

1. Once out of the box, keep the tank upright

at all times as to not apply pressure to divider.

Remove shipping caps from inlet and outlet

ports. Using supplied adapter, connect a

garden hose to the inlet port so the water will

ow into the system and out of the outlet port.

2. Slowly turn faucet on and allow discolored

water to ow from outlet into a suitable

drainage area. The rst few gallons will

appear black and cloudy due to

carbon nes.

TIP: You may need to slightly shake

the tank to help remove carbon nes.

3. After an initial 15-minute ushing, begin

a period of “surge ushing” by turning water

supply on for 30 seconds and then o for 30

seconds, repeating cycle for 15 minutes or

until initial surge of water is completely clear

and free from discoloration and cloudiness.

4. Disconnect the system from the garden hose,

be sure the white washers are properly set

inside the inlet and outlet ports, and position

the system for installation.

INSTALLATION STEPS

Pre-Condition Rhino Tank

Select Location

1. Pick an appropriate installation location. Unit must be installed in an

area where the main water line enters your home, before connecting

to the water heater.

2. Turn o the main water source prior to installation. Drain water from

lines to relieve pressure by turning on a faucet inside your home.

NOTE: DO NOT install after the water heater or on the hot water line.

Components and installation will vary.

NOTE: It’s imperative that this system is ushed properly prior to nal installation.

The granular carbon used in the bottom tank contains 1-2% by volume of carbon

nes that must be ushed out prior to use. Surge ushing is the best method for

purging these carbon nes from the media bed.