User Guide

6
☎
US 1-866-877-6637
|
☎
CAN 1-866-766-3426
|
www.aquascapeinc.com
• Install the right sized
Multi-Hose Adapter based
on the diameter of the
tubing you are using.
• In some instances the tubing/hose may be tight and
difficult to use with hose fitting barbs. If this is the case
we recommend heating the hose with the use of a hair
dryer or simply dipping the hose for a few seconds in very
hot water. Lubrication can also be used; we recommend
silicone grease or olive oil. We recommend putting the
tting on the lter before attaching the tubing/hose. Once
the tting is in place, attach the tubing/hose onto the tting
with a twisting motion pushing it into place.
• Lower the pump into the skimmer (refer to image) or
Pondless
®
filter (refer to image) and rotate the Rotational
Ball Output to line up with the tubing. Attach tubing to
the fitting and then tighten a hose clamp (not included) to
secure tubing onto the fitting.
• If using pipe with a larger
diameter than the smaller
fittings of the Multi-Hose
Adapters, cut off the
smaller section to avoid
any flow restriction.
OR
Skimmer application
• It is recommended to mount the receiver above the ground
on a post, fence or wall.
• Plug the pump into the receiver making sure that blue plug
gasket is in plug port.
• Plug the Receiver into an external GFI-rated electrical source.
In-Line Operation
• The AquaSurge
®
PRO pump can also be operated “in-line”
by attaching a pipe connected directly from the pond (or
aquarium) to the male-threaded pump inlet. In this case
the water must be pre-filtered of debris in order to prevent
any damage to the pump or impeller. The pump must
NEVER be operated dry without water. This pump is water-
cooled and requires water flowing through the pump at all
times for the pump to operate correctly and stay cooled so
it doesn’t overheat.
Pondless
®
Waterfall application
Operation and Maintenance
Remote Control and Receiver Operation
• Receiver Switch – The Receiver includes a
switch that allows the pump to be operated
in the two following modes:
O
Position 1 - Operated by Remote Control
–
Position 2 - Bypass the Remote, and operate at
full flow-rate
In the event of a power loss when operating in the Remote
Control setting, the pump will revert to the last flow-rate setting.