Installation Guide

4
Lowes.com
ASSEMBLY INSTRUCTIONS
Install the spout (A):
a. Remove the preassembled metal washer (G) and
nut (H) from the spout (A) and place the spout (A)
through the center hole of the sink.
b. From underneath the sink, thread the metal washer
(G) and nut (H) onto the spout (A).
c. Turn the nut (H) clockwise to secure the spout (A) to
the sink.
A
G
H
2
Install the hot and cold end valves (B and C).
a. Position the hot and cold end valves (B and C)
on the sink. Ensure that the handles are installed
pointing away from the spout (A).
b. From underneath the sink, thread the washers (D)
and brackets (E) onto the hot and cold end valves
(B and C). Hand-tighten the brackets (E).
c. Secure the valves (B and C) to the sink by
inserting two locking screws (F) into each bracket
(E). Securely tighten.
B
A
C
3
F
E
D
Attach the hose (J):
a. Align the blocks (I) and tabs (L) on the quick
connects (K).
b. Push the quick connects (K)
upward and
snap onto the blocks (I).
c. Pull down moderately to ensure each connection
has been made. If it is necessary to remove the
hose (J), press on the tabs (L) and pull the quick
connects (K) down.
J
4
I
L
K
Install the spout (A):
a. Remove the preassembled metal washer (G) and
nut (H) from the spout (A) and place the spout (A)
through the center hole of the sink.
b. From underneath the sink, thread the metal washer
(G) and nut (H) onto the spout (A).
c. Turn the nut (H) clockwise to secure the spout (A) to
the sink.
A
G
H
2
2.
3.
4.