Installation Guide
3
INSTALLATION INSTRUCTIONS
1. Install Floor Bolts
NOTE: Inspect existing oor ange for damage. If it
is damaged, replace the ange before proceeding.
Replace old T-bolts with new T-bolts (AA), then hand-tighten the
bowl nuts (DD) onto the T-bolts.
2. Install Wax Ring
Turn the bowl (A) upside down and rest it gently on the oor
on something soft (i.e. a towel or piece of cardboard) to avoid
scratching the nish. From the bottom of the bowl (A), rmly
press the wax ring (BB) onto the outlet.
NOTE: If wax ring has an integral plastic ange, be
sure ange taper points away from the toilet.
BB
3. Position Bowl on Floor Flange
Lower the bowl (A) onto the T-bolts (AA), making sure the
T-bolts (AA) protrude through the mounting holes in base of the
bowl (A).
NOTE: Keep the bowl level as it is lowered onto the
oor ange. You may need a second person to help
lift the bowl.
Once the bowl is in position, press down with a slight twisting
motion on the top center of the bowl, eventually applying
full body weight to evenly compress the wax ring to create a
watertight seal. Make sure the bowl is as level as possible.
CAUTION: Do not rock the bowl back and forth as
this may break the seal.
TIP: It may be necessary to use small wedges
(shims) under the edge of the bowl due to slight
variations in vitreous chinaware or uneven oors.
The bowl should be rmly seated on the oor so it
does not wobble or rock.
BB